Preparation And Check Before Use - Toshiba RAV-SM562XT-E Owner's Manual

NAMES AND FUNCTIONS OF INDICATIONS ON REMOTE
CONTROLLER
Display
All indications, except for clock time indication, are indicated by pushing the START/STOP button.
(1) Transmission mark
This transmission mark (,) indicates when the remote controller transmits signals to the indoor unit.
(2) Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Dry, : Heat,
(3) Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
setting is indicated.
(4) FAN speed display
Indicates the selected fan speed. AUTO or one of five fan speed
levels (LOW , LOW
HIGH
Indicates AUTO when the operating mode is either AUTO or
: Dry.
(5) TIMER and clock time display
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER operation.
(6) Hi POWER display
Indicates when the Hi POWER operation starts.
Push the Hi POWER button to start and push it again to stop the
operation.
(7) (MEMORY) display
Flashes for 3 seconds when the MEMO button is pushed during
operation.
mark is indicated when keeping the button pushed for more
than 3 seconds while the mark is flashing.
Push another button to turn off the mark.
(8) ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display changes in the
sequence of 1, 3, 5 or 9h.

PREPARATION AND CHECK BEFORE USE

Loading the remote controller batteries.
(1) Remove the cover, and insert the batteries.
(2) Push the RESET button.
The clock display flashes.
Adjust the clock.
Place back the cover.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep from the
indoor unit or when the air conditioner cannot be operated using
the remote controller.
• To avoid malfunctions by battery leakage, remove the batteries
when not using the remote controller for more than one month.
: Fan only)
: Fan only, no temperature
+
, MED
) can be indicated.
: Cool,
+
, MED ,
• Slide off the cover while
pushing the sides.
• Battery replacement
Be careful not to
reverse the (+) position
and the (–) position.
5
(3) (1) (2) (7)
AUTOA
A
B
(8) (6) (4)
• In the illustration, all indications
are indicated for explanation.
During operation, only the
relevant indications will be
indicated on the remote controller.
AUTO
A
B
FAN MODE AUTO
SWING ECO Hi-POWER
TIMER
MEMO
FIX
ON OFF SET CLR
(2)
FILTER
RESET CLOCK CHECK
(5)