Table of Contents
Advertisement
To avoid electric shock, disconnect the test leads when the rotary switch is in the MEM position.
In MEM function, each operation could only read or clear the data of one storing part.
2. Turn the rotary switch to the MEM position and "
3. Press pushbutton to select a storing data.
Press
for saved reading, "MEM" appears in the display.
Press
for logged reading, "LOG" appears in the display.
Press
for comparative reading, "COMP" appears in the display.
4. Press
or
5. Turn the rotary switch to any other position to enter measuring mode.
Clearing Memory
Use the following procedure to clear memory data:
1. Disconnect the input leads at the measurement source.
To avoid electric shock, disconnect the test leads when the rotary switch is in the MEM position.
In MEM function, each operation could only read or clear the data of one storing part.
2. Turn the rotary switch to the MEM position.
3. Press pushbutton to select a storing data to clear.
Press
to clear saved reading, "MEM" appears in the display.
Press
to clear logged reading, "LOG" appears in the display.
Press
to clear comparative reading, "COMP" appears in the display.
4. Press
for more than 2S, "
else press
to cancel.
Using Communications
Make sure your PC has been connected with the earth ground when employing this function.
When using a PC-to-meter IR (infrared) communication link, refer to the DMMVIEW_A Software Guide or the on line help.
You can use the USB to UART Bridge Controller and DMMVIEW_A software to transfer the contents of a meter to a PC.
to view the sequent or the previous recording.
" appears in the display and press
www.tmatlantic.com
Warning
Notice
" displays on the screen.
Warning
Notice
Notice
- 22 -
again to clear the type of memory presently; or
Advertisement
Table of Contents
