Table of Contents
Advertisement
Do not apply more than DC 1000 V or AC 750 rms voltage; the meter will possible be damaged though the value
could be displayed.
Indicator " " is on display for safety note when 30 V ac and/or dc voltage present at the input terminals
The meter beeps constantly if the input voltage is more than AC 750V rms, which is over the meter's range.
Measuring DC mV Voltage (See Figure 3-4)
1. Set the rotary switch to
2. Insert the black lead into "COM" terminal, and the red lead to into the "Ω
3. Connect the leads to the tested power.
4. Read the measuring results from the screen.
Measuring TC
1. Set the rotary switch to
2. Insert TC into "COM" and "Ω
terminal.
3. Read the measuring results from the screen.
www.tmatlantic.com
Figure3-3.DC Voltage Measurement
Warning
position, and "DC" "mV" will be on display.
Figure3-4.DC mV Measurement
position, and press blue button ( ) to select TC measurement.
V" terminals, make sure the TC jack with symbol "+" is connected into the "Ω
V" terminal.
- 15 -
V"
Advertisement
Table of Contents
