Turning The Power Off - Panasonic WJ-HD88 Operating Instructions Manual

1.4 Modification of the System Time
When this unit is used for the first time, set up the system
time with the procedures specified below. This system time
should be checked periodically. If it seems to be incorrect,
readjustments are needed.
(1) Click the [MENU] button to display the setting menu.
WJ-HD88 SETUP MENU
SYSTEM MANAGEMENT
SEARCH
REC&EVENT SETUP
PTZ SETUP
CAMERA SETUP
COMMUNICATION SETUP
REPORT
USER INFORMATION
DATA MANAGEMENT
(2) Move the cursor to "SYSTEM MANAGEMENT" and
press the [SET] button.
The "SYSTEM MANAGEMENT" menu appears.
SYSTEM MANAGEMENT
SYSTEM SETUP
DISK INFORMATION
REBOOT SYSTEM
PICTURE ADJUST
TIME & DATE
VERSION
(3) Move the cursor to "TIME & DATE" and press the [SET]
button.
"TIME & DATE" menu appears.
TIME & DATE
YYYY-MM-DD
2005-01-28
OK
Move the cursor to the correcting position.
(4) Enter the local time by using Buttons [0] - [9].
(5) Move the cursor to [OK] and press the [SET] button.
(6) End of setting
When the [ESC] button is pressed several times, the
screen returns to the previous menu "SYSTEM MAN-
AGEMENT".
HH:MM:SS
10:43:38
Cancel
Note: If time is corrected in the middle of recording,
part of the recorded data may fail to be played. This
is because some turbulence can arise in the record
start time and the end time.

1.5 Turning the Power Off

The power supply for this unit cannot be turned off if hard
disk data are being played or data are being recorded on
the hard disk. Operation for playback or recording has to
be stopped first. Turn off the power supply after confirming
that the HDD indicator of the front panel is not lit.
(1) Stop the manual recording.
• Select the desired image to be stopped by using the
camera selection button (1 - 8) or the direction button
(up/down).
Hold down the [STOP] button for 2 seconds.
The Record indicator of the numerical keys goes off
and recording is stopped.
• For timer recording, terminal recording, or VMD record-
ing, set up "On" or "Off" for each one with "WJ-HD88
SETUP MENU" – "REC&EVENT SETUP", and then stop
recording in the above procedures.
(2) Stop playback.
• Select channel 1 by using the camera selection button
(1 - 8) or the direction button (up/down), and press the
[STOP] button. Playback is stopped.
(3) Turn off the power switch on the rear panel.
• Turn off the power supply after confirming that the HDD
indicator of the front panel is not lit.
• Check the [OPERATE] indicator. If this indicator is not
lit, the power supply has been turned off.
Note: If this unit is not used for a long time, pull out the
power cord from the power connector.
25