Advertisement
Power Supply Preparations
Refer to the specifications {page 4) tor information on operating times when using rechargeable battenes or dry-cell battenes
Using rechargeable batteries
Obtain the optional rechargeable batteries for SL $120
Make sure to recharge the battenes before using them The unit
cannot be used to charge rechargeable batturis other than those
specifically designed for 1
*Supphed battenes (RP-BPed)
$ Optional batteries (SH-CDB8D}
Recharging procedure
{T
insert the special rechargeable bat-
ternes into the unit
2
Connect the AC adaptor
DC IN jack (DCIN45V
oe)
AC power
outlet
Back panel of the unit
| AC adaptor
`t
3
When
recharging
is complete,
un-
plug the AC adaptor from the power
outlet and the DC IN jack
Accidental Operation
Prevention Function
èlt takes approximately
three
hours
to fully recharge
the
rechargable batteries
Rechargeable battenes hare a service life of approximately
300 charge-discharge cycles It the operating time on one full
charge becomes noticeably shorter than it used to be the bat-
tery has reached
the end of its service life and should be re-
placed
è You can operate the unit with the AC adaptor while recharging
the battenes but it will lengthen the recharging time
®The AC adaptor and rechargcable baticries may become warm
while recharging 1s in progress This 1s not a malfunction
lf the
battery
lid
comes
loose
Slidt
the
lid
back
into
place honzontally
Removing
batter-
IES
Push up on the battery in
the direction indicated by
the arrow
Then lift it out
Using the AC adaptor
Connect the AC adaptor supplied
Refer to
Using rechargeable batteries
for connection instruc
tons
HOLD mode
This function causes the umit to inore short
accidental button presses (The disc lid can still
be opened and closed )
"thoi d" Indication
When the unit is m hold status, pressing any
operation button (other than the OPEN button)
causes the indication
halg
to appear on the
The
mtsoperation
prevention
function prevents the following
*Powering on the unit accidentally (which can
cause the battenu » to go dead)
silay being, cut otf unexpectedly in the middle
of a selection
display
To use the accidental
operation
prevention function
Set HOLD to the HOLD position
b Ii button is pressed
lease the unit trom the hold mode
When the unit ts powered off
Open button (OPEN)
Using the car adaptor (not included)
Be sure to obtain the car adaptor (SH-CD€9) available a» an op
ftonal accessory
The car adaptor can be used to recharge the
unit s batteries while in the car
CAUTION
Use only car adaptor
Madel
SH-CDC9 manufac-
tured by Matsushita Electric Industnal Co , Ltd
Using dry-cell batteries
(not included)
After disconnecting the AC adaptor insert two
AA
size (I R6)
alkaline battenes
The procedure for inserting and removing dry-cell
batteries is identical to that for rechargeable bat-
teries
Battery indicator
a
Battery indicator
This indicator flashes on and off when the battenes are almost
oul of power Power is cut off completely a short whilc later
Rechargeable batteries
Recharge battenes
Ory-cell batteries
Reptace batteries with new ones
*The length of time the unit wall continue to operate between
when the battery indicator starts flashing and when the power
1s cut off differs depending on the ty pe of battenes used
*The battery indicator may not flish if rechargeable batteries
Other than those designated by Panasonic are used
Back panel of
the unit
The 'ho i d" indication appears only when the
@ Skip/search buttons
@ Headphones volume contro!
(dd, bhi «SKIP
œ SEARCH)
(VOLUME)
© Display
@ XBS selector (XBS)
Before operating the buttons
@ Push button (PUSH)
@ Headphones sack (9)
Be absolutly sure to move HOLD to re-
© Play/pause button (> 11)
@ Play mode selector
@ Stop/power off button
(RESUME, NORMAL, RANDOM)
(B, POWER OFF)
@ Hold switch (HOLD)
Q Memory/recatl button
© Out jack (OUT)
(MEMORY/RECALL)
© OC in jack (DC IN45V
o<-e)}
© Repeat button (REPEAT)
@ Hole for car insulator
mounting
Q
screw
Advertisement
