Panasonic WJ-HD88 Operating Instructions Manual page 21

I DIP Switch Setting
When this unit is connected to any other system unit, it is necessary to set up the 2-bit DIP termination switches located on the
back of this unit.
DIP termination switches:
1 2
The dip switch positions are defined by the attribute of the unit connected to the system's DATA terminal.
Machine connected to the DATA port Termination switch 1 Termination switch 2
Controller ON OFF
* Refer to the label in regard to setting the DIP termination switches on the rear panel.
Caution: Switch 2 of the DIP termination switch is not available.
21