Panasonic WJ-HD88 Operating Instructions Manual page 12

4. Ready the hard disk and install wire jumpers.
To connect two hard disks to one IDE interface, make sure to designate one as the Master HDD and the other the Slave
HDD. If only one hard disk is connected, make this the Master HDD. (For connection of the Master and Slave HDD, refer to
the operating instructions of the hard disk.)
Pay attention to the following when choosing the connection position of the Master and Slave HDD.
(1) When connecting two hard disks to IDE port 1, make the one on the left the Master and the one on the right the Slave, as
seen from the front of the recorder. See Fig. 3.
(2) When connecting three pairs of hard disks to IDE port 0, 2 and 3 (6 in total), make the top one the Master and the bot-
tom one the Slave (see Figs. 3 and 5).
Master HDD of
IDE port 1
HDD connected
to IDE port 0
Note: Port 0 was installed to the two disks installed model. Port 0 and 1 were installed to the four disks installed model.
(For the relation between hard disk positions refer to the figure above or the explanation on hard disk management on
page 47.)
5. Insert the hard disk into the hard disk fixing frame.
Fix it with four screws at the side of the frame. (Fig. 4, 5)
6. Insert the hard disk fixing frame in the proper location inside the recorder and fix it with a screw (Fig. 6). (Be careful not to
damage the fan connection terminal and hard disk cable.)
12
Fig. 4
Fig. 6
Slave HDD of
IDE port 1
HDD connected
to IDE port 2
Fig. 3
Fig. 5
HDD connected
to IDE port 3
Master HDD
Slave HDD
Fig. 7