Installing The Light Kit - HAMPTON BAY Bay Island Owner's Manual

Installing the Light Kit

CAUTION
BEFORE STARTING INSTALLATION, DISCONNECT
THE POWER BY TURNING OFF THE CIRCUIT
BREAKER OR REMOVING THE FUSE AT FUSE
BOX. TURNING POWER OFF USING THE FAN
SWITCH IS NOT SUFFICIENT TO PREVENT
ELECTRIC SHOCK.
ATTENTION
FAN INCLUDES A 190W LIMITER TO COMPLY
WITH THE DEPARTMENT OF ENERGY 2009
REGULATION. LAMPING THIS PRODUCT OVER
190W WILL CAUSE THIS FAN TO NOT LIGHT.
PLEASE USE BULBS WITH A TOTAL WATTAGE
UNDER THE 190W REGULATION.
While holding the light kit assembly under
1.
your fan, snap the wire connection plugs
together (Fig. 14).
2. Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 14)
3. Install 3 x 40 watts candelabra bulbs (included)
into the light kit sockets. NOTE: CFL bulbs
are NOT dimmable.
4. Remove the metal nut, metal cap and decora-
tive nut from the light kit. Place glass shade
over the light kit stem, secure with the metal
nut (rubber side on the top), metal cap and
decorative nut. Do not overtighten (Fig. 14).
5. Insert the 2 pull chain through the eyelet in the
shade and cap. Secure the metal cap and
decorative nut provided (Fig. 14).
8
NOTE
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND THE
BULBS SO THE CHAIN DOESN'T RUB AGAINST
ANY OF THE BULBS.
6. Restore power and your light kit is ready for
operation.
Wire Connection
Plugs
Light Kit
Assembly
Bulbs
Metal Nut
Metal Cap
Decorative Nut
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
Fan without Light Kit
(Optional)
1. Disassemble the switch housing from the light
kit, you can keep the light kit for future use.
Attach the plastic plug to the switch housing.
2.
(Fig. 15)
3. Holding the switch housing under your fan,
snap the wire connection plugs together .
Mounting Plate
Install the switch housing to the mounting
4.
Screws
plate with screws provided. (Fig. 15)
Pull Chain
Wire Connection
Plugs
Glass
Shade
Washer
Switch Housing
Plastic Plug
Figure 14
Mounting Plate
Nut
Screws
Figure 15