Ec Declaration Of Conformity - DeVilbiss GTI W Operation Manual

E
GTI W – Trans-Tech Gravity- Feed Spray Gun
Read and follow all instructions and Safety Precautions before using this
The GTI W– Gravity-feed Spray gun Kit is approved to ATEX regulations 94/9/EC, protection
Important: These spray guns are suitable for use with both water-based and solvent-based
coating materials. The design uses EPA compliant atomising (Devilbiss Trans-Tech®) technology
to reduce overspray and improve coating efficiency. Nozzles and needles are manufactured in
stainless steel. These guns are not designed for use with highly corrosive and/or abrasive
materials and if used with such materials it must be expected that the need for cleaning and/or
replacement of parts will be increased. If there is any doubt regarding the suitability of a specific
material contact your local Distributor or ITW Finishing direct.
Example:
Air Cap No.

EC Declaration of Conformity

We, ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the
manufacturer of the Spray gun model GTI-G, declare, under our sole responsibility, that the
equipment to which this document relates is in conformity with the following standards or other
normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the
protection requirements of Council Directive 98/37/EEC relating to Machinery Safety Directive,
and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres protection level II 2 G X.
This product also complies with the requirements of the EPA guidelines, PG6/34. Transfer efficiency certificates are available on request.
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
Operation Manual
Important
equipment
Description
level; II 2 G X. Suitable for use in Zones 1 and 2
Model Part No.
Gun Body Colour
W = light blue;
B. Holt, General Manager
30
2
GTI-G110W-13-US
th
June 2003
Nozzle Size
© 2006 ITW Finishing Systems and Products