Insert Tools, Accessories; Specifications; Technical Data - Hilti TE 70 Operating Instructions Manual

2.11 Using extension cords
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 100V
Mains voltage 110-120 V
en Mains voltage 220-240 V
2.12 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled:
The unit must provide a power output in watts of at least twice the value printed on the type identification
plate on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all
times, frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.

3. Insert tools, accessories

Hammer drill bits
Breach bits
Percussion core bits
PCM diamond core bits
Chisels
Wood drill bits
Metal drill bits
TPS theft protection system with company card,
company remote and TPS‑K key
Setting tool
Quick-release chuck
Mixing paddles for non-flammable materials, with
smooth or hex. shank

4. Technical data

Right of technical changes reserved.
Power tool
Weight in accordance
with EPTA procedure
01/2003
20
1.5 mm² 2 mm²
30 m
20 m 30 m
30 m
Ø 12...45 mm
Ø 40...80 mm
Ø 45...150 mm
Ø 42...132 mm
Pointed, flat and shaped chisels with TE‑Y connection
end
Ø 10...32 mm
Up to Ø 20 mm
Option, 206999
Setting tool with TE‑Y connection end , 32221
Keyless chuck for wood and metal drill bits with
smooth or hex. shank, 60208, Chuck holder 263359
Ø 80...150 mm, 41215 (Ø80mm), 41216
(Ø110mm), For use only with the keyless quick-
release chuck
TE 80‑ATC TE 70‑ATC
10.2 kg 8.9 kg
2.5 mm² 3.5 mm²
50 m
40 m
75 m
TE 70
7.7 kg