Insert Tools, Accessories; Technical Data - Hilti TE 40 Operating Instructions Manual

2.12 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.13 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit
must provide a power output in watts of at least twice the value printed on the type identification plate on the power
tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.

3 Insert tools, accessories

Designation
TPS Theft Protection System with
Company Card, Company Remote
and TPS‑K key
Chuck
Chuck
Setting tool
Quick-release chuck
Dust removal system
Designation
Hammer drill bits
Hammer drill bits
Breach bits
Breach bits
Percussion core bits
Percussion core bits
Chisels
Wood drill bits
Metal drill bits

4 Technical data

Right of technical changes reserved.
NOTE
The power tool is available in various voltage ratings. Please refer to the type identification plate for details of the
power tool's voltage and power rating.
Power tool
Rated power input
Short designation
TE‑C
TE‑T
Short designation
TE‑C
TE‑T
TE‑C
TE‑T
TE‑C
TE‑T
TE 40 / TE 40‑AVR
1,010 W
Item number, description
206999, optional
305590
285852
Setting tool with TE‑C or TE‑T con-
nection end
Keyless chuck for wood and metal
drill bits with smooth or hex. shank,
Chuck holder
TE DRS‑S
Description
∅ 5...28 mm
∅ 6...32 mm
∅ 30...32 mm
∅ 32 mm
∅ 25...90 mm
∅ 50...90 mm
Pointed, flat and shaped chisels with
TE‑C or TE‑T connection ends
∅ 6...32 mm
∅ 6...13 mm
en
17