In these operating instructions, the designation “the power tool” always refers to the TE 800 or TE 800-AVR Always keep these operating instructions to- breaker. gether with the power tool.
Generation: 01 Make a note of this data in your operating instructions and always refer to it when making an enquiry to your Hilti representative or service department. Serial no.: 2 Safety instructions 2.1 General Power Tool Safety Warnings 2.1.3 Personal safety...
Page 7
"live" frequently for work on conductive materials and could give the operator an electric shock. should be checked at regular intervals at a Hilti Service Center. Under unfavorable circumstances, 2.3 Additional safety instructions...
3.5 Standard equipment includes: To avoid the risk of injury, use only genuine Hilti ac- cessories and insert tools. Power tool Side handle 3.2 Active Vibration Reduction (TE 800‑AVR)
The use of unsuitable grease may cause damage to the cooling of the tool. tool. Only use genuine grease from Hilti. DANGER NOTE Always hold the power tool securely with both hands The chisel can be adjusted to 6 different positions (in 60°...
Hilti for servicing in good time. carefully and then grease it again lightly with Hilti grease. 7.3 Cleaning or replacing the dust shield It is essential that the dust shield is replaced if the sealing Clean the dust shield on the chuck with a dry, clean lip is found to be damaged.
The chuck is not pulled back fully. Pull the chuck back as far as it will go from the chuck. and remove the insert tool. NOTE If the fault cannot be eliminated by the measures listed above, have the power tool checked by Hilti Service.
9 Disposal Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or Hilti representative for further information.