HAMPTON BAY 52-RDT Owner's Manual

HAMPTON BAY 52-RDT Owner's Manual

Redington iv 52'' ceiling fan

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 52-RDT and is the answer not in the manual?

Questions and answers

Julie Barton
April 26, 2025

What light bulbs just this unit use? How do I order spare parts?

1 comments:
Mr. Anderson
May 14, 2025

The HAMPTON BAY 52-RDT ceiling fan is typically compatible with standard medium base (E26) light bulbs. It usually supports the following bulb types:

- Incandescent bulbs (commonly 60 watts or less per socket)
- CFL (Compact Fluorescent Lamp) bulbs (check wattage equivalence)
- LED bulbs (ensure they are dimmable if the fan has a dimmer feature)

Always check the maximum wattage limit specified for the light kit, and make sure the bulb shape and size fit within the fixture's housing.

This answer is automatically generated

Thomas P OBrien
February 24, 2025

How do I change a receiver on a Hampton Bay ****/light receiver

1 comments:
Mr. Anderson
February 24, 2025

To change the receiver on a Hampton Bay 52-RDT ceiling fan, follow these steps:

1. Turn Off Power – Switch off the power at the circuit breaker to avoid electrical hazards.

2. Remove the Canopy – Use a screwdriver to loosen the screws on the canopy covering the fan’s mounting bracket. Slide the canopy down to expose the receiver.

3. Disconnect the Receiver – Identify the receiver unit inside the canopy. Disconnect the receiver’s wiring from the fan and power supply. The wires are usually color-coded:
- Black (hot) from ceiling to receiver
- White (neutral) from ceiling to receiver
- Blue (light) from receiver to fan
- Black (fan motor) from receiver to fan
- White (neutral) from receiver to fan

4. Remove the Old Receiver – Unclip or unscrew the old receiver from its position.

5. Install the New Receiver – Connect the new receiver using the same wiring configuration as the old one. Secure all wire connections with wire nuts and electrical tape.

6. Secure the Receiver – Place the new receiver inside the canopy, ensuring it is positioned so the canopy can close properly.

7. Reattach the Canopy – Slide the canopy back up and tighten the screws to secure it.

8. Restore Power and Test – Turn the power back on at the breaker. Test the fan and light functions with the remote to ensure the new receiver is working properly.

If the remote does not work, check that the dip switch settings on the receiver and remote match.

This answer is automatically generated

This manual is also suitable for:

Redington iv

Table of Contents

Save PDF