Separator - Oki OKIPAGE18 Maintenance Manual

3.3.1

Separator

(1) Turn the printer power off and remove the Multi Feeder.
(2) Disengage the link and hopper cover.
(3) Remove two screws 1, disengage two locks of the upper cover 2 using a flat-head
screwdriver, and remove the upper cover 2.
(4) Remove two pan-head screws 3 and remove the cover frame 4.
(5) Disengage the plate and the frame. (Refer to 3.3.6.)
(6) Remove two screws 5 and remove the separator assy 6.
(7) Lift the paper stay 7 and disengage it from the separator bracket 8, then remove the
separator 9. The spring 0 comes off at the same time, so be careful not to lose it.
5
B
3
C
[Check at the time of assembly)
When the secondary stage of idle gear A is turned in the A direction after engaging the plate
and the frame, the inclination of the pressure roller B is less than ±0.1 mm against the plate
C, as shown in the right figure. When the inclination of the pressure roller exceeds ±0.1 mm,
fine-adjust it by pressing with fingers, as shown in the left figure, with the pressure spring
(roller) installed.
40931201TH Rev. 4
1
Lock
4
Lock
3
A
2
6
8
7
9
0
Plate
Plessure spring
(Roller)
2
Less than ± 0.1mm
Plessure roller
231 /