The Printer Does Not Work Normally After Being Turned On - Oki OKIPAGE18 Maintenance Manual

1

The printer does not work normally after being turned on.

• Is
• No
• No
• No
1-1
1-2
40931201TH Rev. 4
message shown in the LCD display (for less than 1 second)?
Is the AC cable connected properly?
• No Connect the cable properly.
Is the message (16 columns
display?
• Yes Replace the Main board.
Are the following voltages applied to the corresponding pins of the POWER
connector on the Main board? (For the measuring points, see Figure 6-1.)
Pin 23: –8V, Pin 24: +8V, Pins 19, 20: +30V
Pins 9-12, 17, 18: 0V,
• No Remove the AC cable. Set the POW switch to the ON position.
Measure the resistance between L and N pins of the AC inlet using a
multimeter. Is there continuity between L and N pins (normal resis-
tance: 554 kΩ)? (For measuring points, see Figure 6-2.)
• No Replace the fuse F2 or the Power Supply Unit (AC120V or
230V)
• Yes Are POWER connector of the Main board and Connection cord-Wire
(26 pin) connected properly?
Are connection cord-wire and CN3 connector of the Power Supply
Unit (AC120V or 230V) connected properly?
• No Connect the connectors properly.
• Yes Are the following voltages applied to CN3 connector of the Power
Supply Unit (AC120V or 230V)? (For measuring points, see Figure 6-
3.)
Pins 19, 20: +30V, Pins 9-12, 17, 18: 0V
Pin 23: –8V, Pins 13, 14: +5V, Pin 24: +8V
• No Replace the Power Supply Unit (AC120V or 230V).
• Yes Replace the Connection cord-wire (26 pin).
• Is the printer recovered?
• No Replace the Main board
• YES END
display only on the top row ) shown in the LCD
Pins 13, 14: +5V
125 /