Oki OKIPAGE18 Maintenance Manual page 118

Category LCD status message
Daily status
READY
ERROR RECEIVE
BUFFER OVERFLOW
ATTENTION
READY
ERROR PRINT
OVERRUN
ATTENTION
READY
ERROR HOST I/F
RS232C
ATTENTION
READY
FRONT TRAY ERROR
PRESS RECOVERKEY
ATTENTION
READY
TONER EMPTY
REPLACE TNR CART
ATTENTION
READY
CHANGE DRUM
ATTENTION
Trouble or status
Informs that the data within the receiving buffer Overflows.
The operation is continued by pressing Recover switch.
The host side should be changed in settings to be able to recognize a
printer Busy status and the data be re-transmitted.
Does not occur in these devices.
Informs that the printer occurs an Overrun. The operation is continued
by pressing Recover switch.
The page formatting should be slightly simplified.
It can be canceled in PS mode when the completion of a job.
Informs that an error occurs in serial I/F. The operation is continued by
pressing Recover switch.
This is indicated when parity error, framing error, overrun error and so
on is detected. The protocol of host and printer should be rechecked.
Informs that an error occurs in the home position of front tray.
Although the front tray becomes unavailable by pressing Recover
switch, the other trays continue operating normally.
Promotes by indication that a cartridge should be replaced after a 100-
sheet printing since the detection of toner low. It is temporarily reset by
opening and closing the cover or pressing "ON LINE" key. This indication
will be displayed each 30-sheet printing unless the cartridge is replaced.
Then, this will recover again by opening/closing the cover or pressing "ON
LINE" key, but this indication appears when every one page is ejected.
During change drum alarm, "CHANGE DRUM/(two line space)" appears
instead of this indication to encourage an operator to replace the drum,
and to prevent toner supply.
Notifies drum life. This temporarity recovers by opening/closing the
cover or pressing "ON LINE" key, but basically the drum should be
replaced.
During change drum alarm, this indication appears. This encourages an
operator to replace the drum and to prevent toner supply.
Remedy
Press the RECOVER key on the operator panel to release
the error display.
Change the setting of the host side so that the host can
detect the busy state of the printer.
Resend the data from the host side to the printer.
Press the RECOVER key on the operator panel to release
the error display.
Simplify page data formatting.
- Press the RECOVER key on the operator panel to
release the error display.
- Check the settings of RS232C I/F in the menu.
- Replace the interface cable or the Main board (Board-FFH).
Note: When replacing the Main board, install the
EEPROM mounted in the replaced Main board.
Check front tray home sensor.
- Replace the toner cartridge.
- Replace the image drum and toner cartridge.
Replace the image drum and toner cartridge.