Paper Input Jam (Front Feeder) - Oki OKIPAGE18 Maintenance Manual

2-2

Paper input jam (front feeder)

• Does jam error occur when the power is turned on?
• Yes
• No
• Yes
• No
• No Does the front feeder paper sensor lever operate smoothly?
• No
• Yes
• Is the printer recovered?
• YES END
• No
B
• No
• Yes
• No
• Yes
2 2 2 2 2 -1-
A
40931201TH Rev. 4
Is the paper at the inlet sensor lever?
• Yes Remove the paper.
A
• No Does the inlet sensor lever operate smoothly?
• No Replace the inlet sensor lever.
• Yes Clean the inlet sensor 1 on the Power Supply Unit (High Voltage) or
replace the Power Supply Unit (High Voltage). (See Figure 2-3
Sensor Layout Diagram.)
Does a jam error occur after paper feeding?
Is the paper fed on the inlet sensor lever?
• Yes Go to .
A
Go to .
B
Replace the lever of the front feeder paper sensor.
Clean the front feeder paper sensor.
Replace the front feeder paper sensor assembly.
Is the hopping roller rotating?
Set the paper properly.
Is the hopping motor rotating?
Replace the front feeder gear or idle gear.
130 /