Table of Contents
Advertisement
3. (Optional) Install Repeater Unit(s) (sold separately)
a) Position the Repeater Unit near the video display (i.e. television, projector) within
330 ft. (100 meters) from the level up device be it the initial transmitter or
another repeater.
b) Connect the video source to the HDMI® Out on the Repeater Unit using an
HDMI® cable.
c) Connect the Cat5/6 cable positioned in Step 2 to the"HDMI® In Link (RJ-45
Connector)" on the Repeater. Connect the Receiver Unit power supply. The Power
LED will light, and LINK LED will turn on after a successful connection between both
units is established. This may take several seconds.
NOTE: These steps can be repeated at each level when adding additional Repeaters
up to 30 levels. Each Repeater has two HDMI® out Links (RJ-45 Connectors) allowing
for the same signal to go in 2 different directions at each level.
4. Install Receiver Unit
d) Position the Receiver Unit near the video display (i.e. television, projector) within
330 ft. (100 meters) from the level up device be it the initial transmitter or
another repeater.
e) Connect the video source to the HDMI® out on the Receiver Unit using an
HDMI® cable.
f ) Connect the provided Receiver Unit power supply. The Power LED will light,
and Link LED will turn on after a successful connection between both units is
established. This may take several seconds.
NOTE: The Receiver should only be used as the last device in the chain as it does not
have an HDMI out port (RJ-45 Connector).
5. Your source video image will now appear on the remote unit(s) attached
video display.
Instruction Manual
6
Advertisement
Table of Contents
