Specifications; Symbols; Intended Use; Power Supply - Makita 3620 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Collet chuck capacity
Plunge capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003

Symbols

The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.

Intended use

The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Model
-1
)
Overall height
Net weight
Safety class
equipment and
) : 89 dB(A)
pA
) : 100 dB(A)
WA
END201-5
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cuttig grooves in MDF
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
its
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENE010-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENF002-2
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
ENG905-1
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Router
Model No./ Type: 3620
are of series production and
Conforms to the following European Directives:
2006/42/EC
2
3620
8 mm or 3/8"
0 - 35 mm
29,000
211 mm
2.5 kg
/II
2
) : 6.0 m/s
h
2
Corporation as the
ENG900-1
ENG901-1
ENH101-15
responsible