Director have reached the end of their life MAKITA INTERNATIONAL EUROPE LTD. must be collected separately and Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 returned to an environmentally com- 8JD, ENGLAND patible recycling facility.
SAFETY INSTRUCTIONS ENA001-2 WARNING: When using electric tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury. Read all these instructions before operating this product and save these instructions. For safe operations: tion and changing accessories.
ADDITIONAL SAFETY RULES ENB033-2 10. Be careful of the bit rotating direction and the Hold tool by insulated gripping surfaces when performing an operation where the cutting tool feed direction. may contact hidden wiring or its own cord. Con- 11. Do not leave the tool running. Operate the tool tact with a “live”...
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Adjusting the depth of cut 003252 Place the tool on a flat surface. Loosen the screw securing the stopper pole. Loosen the lock lever and lower the tool body until the bit just touches the flat surface.
Stopper block 005083 The stopper block has three adjusting hex bolts which raise or lower 0.8 mm per turn. You can easily obtain three different depths of cut using these adjust- ing hex bolts without readjusting the stopper pole. Adjust the lowest hex bolt to obtain the deepest depth of cut, following the method of “Adjusting depth of cut”.
ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing or removing the bit 003257 CAUTION: • Install the bit securely. Always use only the wrenches provided with the tool.
Straight guide 003259 The straight guide is effectively used for straight cuts when chamfering or grooving. To install the straight guide, insert the guide bars into the holes in the tool 003260 base. Adjust the distance between the bit and the straight guide. At the desired distance, tighten the wing bolts to secure the straight guide in place.
Secure the templet to the workpiece. Place the tool on the templet and move 003695 the tool with the templet guide sliding along the side of the templet. NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the bit and the outside of the templet guide.
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.