Table of Contents
Advertisement
Mb LAN Enable/Disable
Change the setting of jumper JP3 to
enable or disable the Mb LAN port on
the motherboard (see Figure 5-4 for
location). Refer to the table on the
right for jumper settings. The default
setting is Enabled.
Gb LAN Enable/Disable
Change the setting of jumper JD3 to
enable or disable the Gb LAN port on
the motherboard. (see Figure 5-4 for
location). Refer to the table on the
right for jumper settings. The default
setting is Enabled.
VGA Enable/Disable
JP4 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
See the table on the right for
jumper settings.
Third Power Supply Alarm
Enable/Disable
The system will notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis, with one acting as a
backup.
If you only have one or
two power supply units installed,
you should disable this (the default
setting) with JP9 to prevent false
alarms. See the table on the right
for jumper settings.
Chapter 5: Advanced Motherboard Setup
Jumper
Position
Pins 1-2
Pins 2-3
Jumper
Position
Pins 1-2
Pins 2-3
5-19
Mb LAN
Enable/Disable
Jumper Settings
(JP3)
Definition
Enabled
Disabled
Gb LAN
Enable/Disable
Jumper Settings
(JD3)
Definition
Enabled
Disabled
VGA Enable/Disable
Jumper Settings
(JP4)
Jumper
Position
Definition
1-2
Enabled
2-3
Disabled
T hird Power Supply
Alarm Enable/Disable
Jumper Settings (JP9)
Jumper
Position
Definition
Open
Disabled
Closed
Enabled
Advertisement
Table of Contents
