Advanced System Configuration - Fujitsu D943 Technical Manual

Advanced - advanced system configuration
PCI Device, Slot #n: Default Latency Timer
specifies the lowest number of clock cycles in which a PCI master board can be
active at the PCI bus;
take effect, you must switch your PC off and then on again after the Setup BIOS
has terminated.
The value predefined by the PCI board is accepted. The entry in
Yes
the corresponding field for PCI Device, Slot #n:
ignored
The value predefined by the PCI board is ignored. The value set in
No
the relevant field of
the number of clock cycles.
PCI Device, Slot #n: Latency Timer
Requirement: The relevant field of
be set to .
No
The field defines the lowest number of clock cycles in which a burst can be
transferred on the PCI bus.
to Number of clock cycles (default entry =
0000h 0280h

Advanced System Configuration

calls the submenu in which you can make additional settings.
Phoenix BIOS Setup
Advanced
Advanced System Configuration
ISA Memory Gap:
Parity Mode:
Memory Performance:
Cache Performance:
Memory Current:
Feature Connector:
↑↓
F1 Help
← →
ESC Exit
Example for submenu
A26361-D943-Z120-14-7619
stands for the number of the PCI slot. For the change to
n
stands for the number of the PCI slot.
n
[Disabled]
[Disabled]
[Fast]
[Fast]
[8mA]
[Disabled]
Select Item -/+
Select Menu Enter
Advanced System Configuration
PCI Device, Slot #n: Latency Timer
PCI Device, Slot #n: Default Latency Timer
Change Values
Execute Command
Settings in BIOS Setup
Latency Timer
determines
).
0040h
Item Specific Help
F9 Setup Defaults
F7 Previous Values
is
must
29