Fujitsu D943 Technical Manual page 36

Settings in BIOS Setup
PCI Interrupt Mapping INTx# - Assignment of the PCI interrupts
defines which PCI interrupt is switched to which ISA interrupt. For the change to
take effect, you must switch your PC off and then on again after the Setup BIOS
has terminated.
A multifunctional PCI board can use all PCI interrupts, if need be.
If you use a setting other than
BIOS for PCI boards is deactivated.
The PCI interrupts INTA#, INTB#and INTC# are assigned as follows:
PCI slot 1 = INTA#, PCI slot 2 = INTB#, PCI slot 3 = INTC#
The PCI interrupts are assigned automatically in accordance with
Auto
the Plug&Play guidelines (default entry).
No PCI interrupt is used for the PCI board in the assigned PCI
Disabled
slot.
IRQ03, IRQ04, IRQ05, IRQ06, IRQ07, IRQ09, IRQ10, IRQ11, IRQ12, IRQ14, IRQ15
The PCI interrupt is switched to the selected ISA interrupt. You
may not select an ISA interrupt that is used by a component on the
system board (e.g. controller) or an ISA board.
VGA Interrupt - Assigning PCI-VGA interrupt
assigns PCI interrupt to the screen controller on the built-in PCI board. If you have
not defined any other interrupt with
The interrupt is assigned to the screen controller on the built-in
Enabled
PCI board (default entry).
The interrupt can be used for other add-on boards.
Disabled
28
Advanced - advanced system configuration
, the Plug&Play functionality of the system
Auto
PCI Interrupt Mapping
, IRQ9 is assigned.
A26361-D943-Z120-14-7619