Syslog Server - Polycom SpectraLink 8000 Administration Manual

SpectraLink 8000 SVP Server: Administration Guide for Mitel and Cisco
28
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
• : The IP address of a network TFTP server that will be
IP Address
used to transfer software updates to the SVP Server.
DNS server and DNS domain
These settings are used to configure Domain Name services. Consult
your system administrator for the correct settings. These can also be
set to . This will cause the DHCP client in the SVP Server to
DHCP
attempt to automatically get the correct setting from the DHCP server.
The DHCP setting is only valid when the IP address is also acquired
using DHCP.
WINS servers
These setting are used for Windows Name Services. Consult your
system administrator for the correct settings. These can also be set to
. This will cause the DHCP client in the SVP Server to attempt to
DHCP
automatically get the correct setting from the DHCP server. The
DHCP setting is only valid when the IP address is also acquired using
DHCP.
When the name services are set up correctly, the SVP Server can
translate hostnames to IP addresses. Using telnet, it is also
possible to access the SVP Server using its hostname instead of
the IP address.
Workgroup
As set in WINS.

Syslog Server

Logging can be set to
Syslog
to the syslog server when an alarm is triggered.
Disable Telnet Service
Prevents Telnet access into the SVP Server. Reset the SVP Server for
the change to take effect. Upon reset the Telnet protocol server is not
started.
The SVP Server must be reset in order to set the configuration options.
If the SVP Server is in
Maintenance Lock
or . If Syslog is set, a message is sent
NONE
, you must manually reset it by
PN: 1725-36031-001_H.doc