To Set The Clock; To Set The Minute Timer; For A Silent Control Panel; Temperature Conversion - Kenmore Slide-in models Use & Care Manual

Setting Oven Controls
Note: The time of day must first be set in order to operate the oven.

To Set the Clock

When the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash
"12:00".
1. Press once (do not hold pad down).
2. Within 5 seconds, press and hold the
Note: The clock cannot be changed during any timed bake or Self-Clean cycle.

To Set the Minute Timer:

Timer
Minuterie
1. Press .
On/Off
2. Press the to increase the time in one minute increments. Press and hold the
increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
Note: If the
pad is pressed first, the timer will advance to 11 hours and 59 minutes.
3. The display shows the timer countdown in minutes until 1 minute remains. Then the display will countdown in seconds.
4. When the set time has run out, the timer will beep 3 times. It will then continue to beep 3 times every 60 seconds until
Timer
Minuterie
is pressed.
On/Off
Note: The indicator light located above the
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set
time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer is
in use with any other function, the minute timer will be shown in the display. To view other functions, press the pad for that
function.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, press and hold the
To Cancel the Minute Timer before the set time has run out: Press
Note: To turn the time of day display OFF or ON in the display press
once) and then release.This feature does not remove the set time of day from the memory of the control. When the display
is turned OFF the time of day will reappear for a few seconds any time the

For a silent control panel

When choosing a function, a beep will be heard each time a pad is pressed. If desired, the control can be programmed for
silent operation. Press and hold
when a pad is pressed. To return the sound, press and hold

Temperature conversion

The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be programmed
for any temperature from 170°F to 550°F (77°C to 287°C).
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):
Broil
Griller
1. Press . "— —" appears in the display.
2. Press and hold the
Broil
3. Press and hold Griller
4. Press the or
5. Press any control pad to return to normal operating mode.
or
Timer
Minuterie
On/Off
Delay Start
Départ
. After 7 seconds, the control will beep once. This will block the controls from sounding
Différé
until "HI" appears in the display.
until °F or °C appears in the display.
to change °F to °C or °C to °F.
until the correct time of day appears in the display.
pad will glow while the minute timer is active.
Timer
Minuterie
On/Off
Delay Start
Départ
again for 7 seconds until the control beeps once.
Différé
12
to increase the time in 10 minute
or
to increase or decrease the time.
.
and hold for 15 seconds (the control will beep
pad is touched.