Using Other Types Of Video Output; Connecting Using The S-Video Output; Connecting Using The Component Video; Output - Pioneer DV-565A Operating Instructions Manual

02 Connecting up
See below if you want to use a SCART cable
for the audio/video connection, or an S-video
or component cable connection.
• If you need another pair of stereo outputs
(and don't need to use the multichannel
analog outputs), you can use the AUDIO
OUT (5.1ch) FRONT L / R jacks (page 16).
2 Connect the supplied AC power cable
to the AC IN inlet, then plug into a power
outlet.
• Before unplugging the player from the
power outlet, make sure you first switch it
into standby using either the front panel
 STANDBY/ON button, or the remote
control, and wait of the -OFF- message to
disappear from the player's display.
• For the above reasons, do not plug this
player into a switched power supply found
on some amplifiers and AV receivers.
• When Component Out (page 56) is set to
Progressive, there is no video output
from the VIDEO OUT (composite) and S
(S-video) jacks. If you want to display video
on more than one monitor
simultaneously, make sure that it is set to
Interlace. Switch the player to standby
then, using the front panel controls, press
 STANDBY/ON while pressing 
to switch the player back to Interlace.
Using other types of video

output

This player has standard (composite), SCART-
type AV, S-Video and component video
outputs. The main difference between them is
the quality of the picture.
S-Video delivers a better picture than
standard composite video, while component
14
En
video gives better picture quality still. The
variety of outputs also gives you the flexibility
of connecting your particular equipment
using the best connection type available.
Connecting using the S-video
output
If your TV (or other equipment) has an S-video
input, you can use this instead of the standard
(composite) output for a better quality picture.
• Use an S-video cable (not supplied) to
connect the S-VIDEO OUT to an S-video
input on your TV (or monitor or AV
receiver).
Line up the small triangle above the jack with
the same mark on the plug before plugging in.
TV
AUDIO OUT(2CH)
Y
P
B
DIGITAL COAXIAL
AUDIO OUT
ceiver
S P
OPTICAL R
VIDEO OUT
COMPONENT VIDEO OUT
S-VIDEO
IN
L
CENTER
L
AUDIO OUT(5.1CH)
R
R
FRONT SURROND SUB
WOOFER