Av Connector Out - Pioneer DV-565A Operating Instructions Manual

Initial Settings menu
• Default setting: Interlace
Initial Settings
Digital Audio Out
TV Screen
Video Output
Component Out
Language

AV Connector Out

Display
S-Video Out
Options
Speakers
If you have a progressive-scan compatible TV,
set this to Progressive for flicker-free video
output. If your TV is not compatible with
progressive-scan video, set to Interlace.
Check the operating instructions that came
with your TV if you're unsure about its
compatibility.
• When setting to Progressive, you have to
press ENTER once more to confirm. See
also below for important information on
progressive scan video.
About progressive scan video
Compared to interlace video, progressive
scan video effectively doubles the scanning
rate of the picture, resulting in a very stable,
flicker-free image. Progressive scan video is
available only from the component video
output.
• When TV system is set to AUTO or NTSC
only: When Component Out (see above)
is set to Progressive, there is no video
output from the VIDEO OUT (composite)
and S (S-video) jacks. If you want to
display video on more than one monitor
simultaneously, make sure that it is set to
Interlace. See also Setting the TV System
on page 73.
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the player to progressive, you will not be
able to see any picture at all. In this case,
switch everything off and reconnect using
Progressive
Interlace
• When TV system is set to AUTO or NTSC
• When TV System is set to PAL only:
Compatibility of this unit with
progressive-scan TVs
This player is compatible with progressive
video Macro Vision System Copy Guard.
CONSUMERS SHOULD NOTE THAT NOT ALL HIGH
DEFINITION TELEVISION SETS ARE FULLY
COMPATIBLE WITH THIS PRODUCT AND MAY
CAUSE ARTIFACTS TO BE DISPLAYED IN THE
PICTURE. IN CASE OF 525 PROGRESSIVE SCAN
PICTURE PROBLEMS, IT IS RECOMMENDED THAT
THE USER SWITCH THE CONNECTION TO THE
"STANDARD DEFINITION" OUTPUT. IF THERE ARE
QUESTIONS REGARDING OUR TV SET
COMPATIBILITY WITH THIS MODEL 525p DVD
PLAYER, PLEASE CONTACT OUR CUSTOMER
SERVICE CENTER.
• This player is compatible with the
AV Connector Out
You only need to make this setting if you
connected this player to your TV using the AV
SCART-type connector.
• Default setting: Video
the supplied video cable (see Easy
connections on page 13), then switch
back to Interlace. Switch the player to
standby then, using the front panel
controls, press  STANDBY/ON while
pressing  to switch the player
back to Interlace.
STANDBY/ON
FL DIMMER
STANDBY/ON
only: When set to Progressive, PAL and
NTSC discs are both output as
progressive NTSC video. See page 73.
Progressive cannot be selected. See
page 73.
following Pioneer displays and monitors:
PDP-503HDE, PDP-433HDE.
09
OPEN/CLOSE
57
En