Connecting Using The Av Connector - Pioneer DV-565A Operating Instructions Manual

Connecting up
Connecting using the
component video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other
equipment). This should give you the best
quality picture from the three types of video
output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
TV
AUDIO OUT(2CH)
Y P
B
DIGITAL
COAXIAL
AUDIO OUT
er
S
P
OPTICAL R
VIDEO OUT
COMPONENT VIDEO OUT
• To set up the player for use with a
progressive scan TV, see Component Out
on page 56.
• Only NTSC video is output when set to
progressive scan.
• When the AV connector is set to output
RGB video, the component video output is
switched off. If you want to use the
component video output, set the AV
connnector to Video or S-video.
COMPONENT
VIDEO IN
L CENTER
L
AUDIO OUT(5.1CH)
R
R
FRONT SURROND SUB
WOOFER
Connecting using the AV
connector output
If your TV has a SCART-type AV input, you can
use a SCART cable to connect this player to
your TV. This type of connection carries both
the sound and the picture, so there's no need
to connect up the AUDIO OUT L/R and
VIDEO OUT jacks.
• Use a SCART cable (not supplied) to
connect the AV CONNECTOR 1(RGB) - TV/
AV Receiver to an AV input on your TV.
TV
AV CONNECTOR 2
This connector can output standard
(composite), S-Video or RGB component
video. The default setting is standard, which
should work with all TVs. Consult the manual
that came with your TV to see if you can use
one of the higher quality settings. See page 57
for how to change the video output.
SCART
DIGIT
CONTROL AUDI
IN OUT
AV CONNECTOR 1(RGB) - TV/AV Receiver
02
15
En