Konica Minolta 7145 Instruction Manual page 103

Punching File Holes in Copies (Punch) (continued)
6.
Enter the desired print quantity from the control panel keypad.
See p. 10-3 for the finisher capacity specifications.
7.
Position original(s).
See p. 3-2 to p. 3-6 for details on positioning originals.
8.
Press [START].
Press [STOP] to suspend the scanning or printing job.
• Finisher FS-113 primary (main) tray gradually goes down while printed
materials output. DO NOT allow any object to interfere with the operation
of the tray on the left side of the finisher, as any interference may cause
damage to the finisher.
• Finisher FS-114 trays gradually go up/down while printed materials
output, depending on the tray selected. With SK-114 Saddle kit, the
operation of the trays become greater. DO NOT allow any object to
interfere with the tray operation on the left side of the finisher, as any
interference may cause damage to the finisher.
When the finisher exit tray capacity is exceeded due to the print
quantity selected, remove the copied sets as they exit; otherwise,
mishandled paper will occur.
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Output with
Finisher
Staple
Punch
Fold /
Fold&Stitch
Output with
Inner Tray
3-45