Troubleshooting - CDA ci261 Manual For Installation, Use And Maintenance

Troubleshooting

All repairing which must be done on the machine should be done
by authorised service agents. When repair is required for your
machine and you are unable to resolve the problem from the
information given below:
• Unplug the machine.
• Close the water tap.
• Contact CDA Customer Care.
Fault
Machine does not start
Machine does not take
In water
Machine does not
discharge water
Possible Causes
It is not plugged in
Fuse has failed
Power cut
''Start/Pause'' button not
pressed
''Programme Control'' knob
on position ''0''
Machine door not properly
closed
Tap turned off
Water inlet hose twisted
Water inlet hose blocked
Valve inlet filter blocked
Machine door not properly
closed
Discharge hose blocked or
twisted
Pump filter blocked
Load unbalanced in
machine
27
Suggested Actions
Plug it in
Replace the fuse
Check mains power
Press ''Start/Pause''
button
Switch ''Programme
Control'' knob to desired
position
Close the machine door
Turn the tap on
Check water inlet hose
Check water inlet hose
Clean the inlet filters
Close the machine door
Check he discharge hose
Clean the pump filter
Spread the load out
within the machine