Troubleshooting - CDA ci325 Manual For Installation, Use And Maintenance

Troubleshooting

All repairs which must be done on the machine should only be
performed by authorised service agents. When a repairs is required
for your machine or you are unable to eliminate the failure with the
help of the information given below:
• Unplug the machine.
• Close the water tap.
• Contact CDA Customer Care.
Fault
The machine will not
start.
The machine does
not filll with water.
The machine is
draining while being
filled.
26
Probable cause
It is unplugged.
The fuse is damaged.
There is a fault with the power
supply.
The washer door is not properly
closed.
"Start / Pause" button has not
been pressed.
Start / Pause" button has not
been pressed.
Water tap is not turned on.
Water pressure too low.
The inlet hose is kinked.
Water supply failure.
Programme knob not set
correctly.
Washer door not properly closed
Inlet hose filter is blocked.
The height of drain hose is below
80cm.
The drain hose is in water.
Methods of elimination
Insert the plug into the socket.
Replace the fuse.
Check the power supply.
Close the washer door.
Press the "Start / Pause" button.
Press the "Start / Pause" button.
Turn on the water tap.
Check water pressure.
Check the inlet hose.
Check the water supply.
Set the the programme knob correctly.
Close the washer door properly.
Unblock the inlet hose filter.
Install drain hose at specified height of
80-100cm.
Ensure the drain hose end is not
immersed in water.