Table of Contents
Advertisement
Failure codes and troubleshooting
Your machine is equipped with diagnostic systems which monitor
wash progress and will intervene to protect the washing machine in
the event of a fault.
Failure
Troubleshooting
All repairing which must be done on the machine should be done by
authorized service. When a repairing is required for your machine or
you are unable to eliminate the failure with the help of the information
given below:
•
Unplug the machine.
•
Close the water tap.
•
Contact CDA Customer Care.
Probable failure
The door is not shut
properly.
Inadequate water
supply.
The pump filter is
blocked or there is a
fault with the pump.
The machine has
overfilled.
Drum motor failure.
The process to be done
Shut the door properly so that you hear the
click.
If the error persists, unplug the machine, close
the water tap and contact CDA Customer Care.
Make sure the water tap is fully open and there
is no fault with the water supply.
Clean the inlet filter as described on page 14.
Restart the washing machine.
If the error persists, unplug the machine, close
the water tap and contact CDA Customer Care.
Clean the pump filter as described on page 15
If the error persists, unplug the machine, close
the water tap and contact CDA Customer Care.
The machine will automatically perform a drain
cycle. Once the drain cycle is complete, unplug
the machine, close the water tap and contact
CDA Customer Care.
Unplug the machine, close the water tap and
contact CDA Customer Care.
33
Advertisement
Table of Contents
