Starting A Wash Programme - CDA ci261 Manual For Installation, Use And Maintenance

Starting a Wash Programme

• Turn the "Programme Control" knob to the required
programme.
• Select any required extra functions, as detailed below.
• Select any required extra options, as detailed below.
• Press the "Start/Pause" button.
When a wash programme is in progress, the programme can be
paused by pressing the "Start/Pause" button at any time. The
programme will pause and the
electronic display, showing that the door can be opened. To
restart the programme, press the "Start/Pause" button again.
For added safety, the porthole door does not open immediately at
the end of programme. There is a time delay of approximately two
minutes before you can open the door.
Programme Selection
To select a programme, turn the "Programme Control" knob to the
required programme, as detailed in the programme table below
and also on the detergent dispenser. The display will show the
programme time, the spin speed, wash water temperature and the
open door or locked door
Spin Speed Selection
When a programme is selected using the "Programme Control"
knob the maximum spin speed for the chosen programme is
initially displayed.
You can reduce the spin speed or switch it off completely if
required by pressing the "Spin Speed" button. Repeated pressing
of this button cycles the speed through all the options between
the maximum for the programme selected and no final spin.
symbol will light on the
symbol..
11