Troubleshooting Guide - ProBoat Ragazza PRB07000 Owner's Manual

Troubleshooting guide

problem
Boat does not respond
to the transmitter
Boat moves too fast or
too slow for the wind
and water conditions
Boat tends to turn one
direction
Boat tends to drift
Boat tends to dive in the
water or takes on water
Winch does not respond
to transmitter, while
rudder does
Boat will not Bind (during
binding) to transmitter
Boat will not connect
(after binding) to
transmitter
Controls reversed
Ragazza
possible Cause
Boat receiver is not bound
to the transmitter
Low or no power
Fouled or broken sails, lines or servo
Rigging may be worn
Sails may be adjusted too tight
Steering rate incorrect on the transmitter
for the wind and water conditions
Vegetation or other obstacles block the
rudder, keel or sails
Sails are not centered
Rudder is not centered
Sails are not centered
The rigging is worn or broken
Rudder is not centered
Sails are rigged too high or low
on the mast
Sails are tied too tight
The boat hull is not completely closed
Winch servo is disconnected
Winch, servo, line or other parts are
blocked or damaged
Servo travel is too low
Trim is incorrect
Transmitter is too near boat during
binding process
Boat or transmitter is too close to large
metal object
Bind plug is not installed correctly
Low or no power
Transmitter is too near boat during
connecting process
Boat or transmitter is too close to large
metal object
Bind plug is left installed in bind port
Boat battery/Transmitter battery charge
is too low
Transmitter may have been bound to a
different model
Transmitter settings are reversed
Solution
Bind the receiver to the transmitter
Replace/recharge batteries
Ensure connections are secure and powered on
Straighten, tighten or replace damaged parts
Repair or replace damaged parts
Loosen or adjust the sail rigging for wind
and water conditions
Adjust the steering rate
Remove boat from the water and obstacles
Center and adjust the sails and control
lines for the wind and water conditions
Adjust or repair rudder, connectors or servo
Center and adjust the sails and control
lines for the wind and water conditions
Repair or replace damaged rigging
Adjust or repair rudder, connectors or servo
Adjust the tightness of the rigging at
the top corner and bottom of each sail
Loosen lines
Dry out the boat and ensure the hatch is fully
closed on the hull before returning the boat
to the water
Connect servo to receiver
Repair or replace parts
Adjust travel
Adjust winch line or transmitter trim
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to boat
Move boat or transmitter away from large
metal object
Install bind plug in bind port and bind boat to
transmitter
Replace/recharge batteries
Ensure connections are secure and powered on
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to boat
Move boat or transmitter away from large
metal object
Rebind transmitter to boat and remove bind
plug before cycling power
Replace/recharge batteries
Bind boat to transmitter
Perform the Control Direction Test and
adjust controls on transmitter appropriately
EN
11