Transmitter Controls; Transmitter Battery Installation; Binding - ProBoat Ragazza PRB07000 Owner's Manual

EN

Transmitter Controls

For more information on the transmitter, go to
www.horizonhobby.com/products/SPMR2200
and click on the support tab for the Spektrum
DX2M to download the instruction manual.
Winch Trim
Move the slider to change
the winch trim.
Bind Button
Push and hold to bind
Winch Control
Move the Winch Control
UP on the transmitter to
release the control lines.
Move the Winch Control
DOWN to pull in the
control lines.
50/50, 70/30 Switch
Adjusts the ratio of travel
forward and backward
between 50/50 and 70/30.
power Switch
Power on or off the
transmitter

Transmitter Battery Installation

This transmitter operates on 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.

Binding

Your boat comes bound to the included transmitter. Only
perform the following steps if the boat does not respond
to the transmitter or you wish to bind the boat to another
compatible transmitter.
1. Ensure the transmitter is powered off.
2. Put a bind plug in the BND/BAT port of the receiver.
3. Correctly connect the battery holder (with batteries
installed) to the marked + and - pins of the THR
or STR port.
4. Hold down the bind button on your transmitter
while powering on the transmitter.
4
Reverse Switch
Allows you to change the direction of the
winch and rudder controls (Ensure proper
function with a radio system test).
5. When the receiver LED blinks (indicating bind
is complete), release the bind button on your
transmitter.
lEDs
Battery Level Indicator
Steering Rate knob
Steering rate limits the
amount of travel of the
steering servo.
Rudder Control
Move the Rudder Control
RIGHT to move the
rudder right. Move the
Rudder Control LEFT to
move the rudder left.
Rudder Trim
Steering trim is adjusted
until the vehicle tracks
straight.
Ragazza