Changing The Light Bulbs; To Change The Refrigerator Light; To Change The Crisper Light - Whirlpool Side by side Refrigerator/Freezer Use & Care Manual

CHANCING II~E ucm Bum
I
Y
tif
h
C
tt
rf
tt
tc
h
Y
0
7
1
2
1
1
:
I
.
I
t
t
:
(
I
r
Electrical Shock Hazard
Unplug the refrigerator before removing a
light bulb.
Failure to do so can result in death or
electrical shock.
our refrigerator has several light bulbs. This sec-
on shows you where they are located and tells you
ow to change them if they burn out. Before you
hange any light bulb in your refrigerator, be sure to
Jrn the Refrigerator Control to OFF and unplug the
zfrigerator. After you have replaced the bulb, plug
le refrigerator in and reset the Refrigerator Control
3 the desired setting.
IOTE: Not all commercial appliance bulbs will fit
our refrigerator. Be sure to replace the bulb with
ne of the same size and shape.
'o change the refrigerator light:
/. Reach behind the Control Panel and remove
the bulb.
!. Replace the bulb with a 40-watt appliance bulb.
To change the crisper light:
1. Pull the top of the light shield forward until
it snaps free and lower until the light bulb
is visible.
!. Replace the bulb with a 40-watt appliance bulb.
3. Pull the top of the light shield up over the bulb
and snap it onto the side wall supports.
rlOTE: To remove light shield for cleaning, remove
,he crisper and the crisper cover. Then release the
lottom of the shield from the lower side wall
UpportS. Pull the light shield out from above the
;risper cover and wash it with warm water and a
iquid detergent. Dry the cover and replace it in the
.everse order.
26
WITH QUESTIONS OR COMMENTS