Venting Requirements; Wall Termination Venting- With No Vertical Rise - Pacific energy fusion gas Installation And Operating Instructions Manual

Venting
Requirements
The Fusion Gas stove installation and
venting must conform with local
codes or, in the absence of local
codes, to the current Installation
Code, CAN/CGA-B149.1 in Canada
or the current National Fuel Gas
Code, ANSI Z223.1 in the USA. Only
qualified (licensed or trained)
personnel should install this product.
The Fusion Gas Heaters are tested
and certified for use with SIMPSON
DURA-VENT DIRECT VENT GS pipe
or SECURITY CHIMNEYS SECURE
VENT system. Vent components
approved for use are listed on page
14. Kits for venting either through the
wall or vertically through the roof are
available from the vent system
manufacturer or your nearest Pacific
Energy Authorized Dealer. Before
installing the vent system, the
installer should read these
instructions to ensure proper
installation requirements are
maintained.
NO OTHER VENTING SYSTEMS OR
COMPONENTS MAY BE USED.
CAUTION: UNDER NO CONDITION
SHOULD COMBUSTIBLE
MATERIAL BE CLOSER THAN 1
INCH FROM ANY VERTICAL OR
HORIZONTAL VENT SECTIONS.
Venting must be installed as per the
venting manufacturers instructions –
see information supplied with the vent
system.
Consult your local Building Codes
before beginning the installation.
10
070905-28
Venting For Wall Termination
With No Vertical Rise
Fig. #4
Maximum vent length is 24".
14" Snorkel Vent Terminal
must be used for all rear
vent applications. Where the
terminal is accessible a
guard, such as Simpson
Dura-vent part # 984SG,
must also be used.
Fig. #5
14" Snorkel
termination
Maximum of one 45° elbow may
be used, but the maximum vent
length must be reduced to 18".
14" Snorkel Vent Terminal must
be used for all rear vent
applications. Where the terminal
is accessible a guard, such as
Simpson Dura-vent part # 984SG,
must also be used.
FSGA
14" Snorkel
termination
24"
18"
5056.4221