Pacific energy SERIES A Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Pacific energy Manuals
  4. Indoor Fireplace
  5. Series A
  6. Operating instructions manual

Pacific energy SERIES A Operating Instructions Manual

Gas insert. vented gas fireplace heater
Hide thumbs Also See for SERIES A:
Table of Contents

Advertisement

Quick Links

See also: Installation Manual
f i r e - p a r t s . c o m
Pacific Energy Fireplace Products Ltd.
Box 1060, Duncan, BC V9L 3Y2
Phone: 250-748-1184
Web site: http://www.pacificenergy.net
THESE INSTRUCTIONS ARE TO
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
-- Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
-- WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance.
- Do not touch any electrical switch; do
not use any phone in your building.
- Immediately call your gas supplier
from a neighbour's phone. Follow the
gas supplier's instructions.
- If you cannot reach your gas supplier,
call the fire department.
-- Installation and service must be
performed by a qualified installer, service
agency or the gas supplier.
Printed in Canada
090701-24
IMPORTANT:
REMAIN WITH THE
HOMEOWNER
Fairfield-A
Fairfield
Gas Insert
SERIES A
VENTED GAS FIREPLACE
HEATER
INSTALLATION
AND
OPERATING
INSTRUCTIONS
5056.425

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SERIES A and is the answer not in the manual?

Questions and answers

Related Manuals for Pacific energy SERIES A

Summary of Contents for Pacific energy SERIES A

  • Page 1 -- Installation and service must be performed by a qualified installer, service SERIES A agency or the gas supplier. VENTED GAS FIREPLACE HEATER INSTALLATION Pacific Energy Fireplace Products Ltd. Box 1060, Duncan, BC V9L 3Y2 Phone: 250-748-1184 OPERATING Web site: http://www.pacificenergy.net INSTRUCTIONS Printed in Canada...

  • Page 2: Table Of Contents

    DEGAGEMENT DES MATIERES INFLAMMABLES Encart de la cheminée Adjacent Sidewall / Mur du côté adjacent : 9.5 in. / 9.5 po. (241 mm) PACIFIC ENERGY Propane Conversion ................17 Ceiling / Plafond : 38 in. / 38 po. (965 mm) FIREPLACE PRODUCTS LTD.

  • Page 3: Caution

    .....Brick Panel Set ........5094.2451 17 ..Burner Pan Assembly ......BRNA.1987 All parts may be ordered from your nearest Pacific Energy Gas Stove dealer. Contact Pacific Energy for the location of the dealer Fig. # 1 f i r e - p a r t s . c o m nearest you.

  • Page 4: Maintenance

    Remove all particles of glass. Be careful as they are very sharp. Install new glass complete with gasket. Replace frame. It is Pacific Energy’s policy that no responsibility is assumed by the Company or by any of its employees or representatives...

  • Page 5: Installation

    * Standard-size Surround Assembly, Embossed Bevelled Panels ........37" wide x 25" high ** Over-size Surround Assembly, Plain Flat Panels ............43" wide x 28" high All parts may be ordered from your nearest Pacific Energy dealer. Contact Pacific Energy for the location of the dealer nearest you.

  • Page 6: Clearances

    Clearances Fig. # 37 Fig. # 6 The Fairfield Insert is designed to be installed into a masonry or a factory built zero clearance fireplace. The masonry fireplace must be built according to the requirements of the Combustible Mantel Standards for Chimneys, Fireplaces, Vents and Solid Fuel 4) Run the power cord to the outside of Burning Appliances, NFPA 211 (Latest Edition) or applica- the appliance through the foremost...

  • Page 7: Venting

    Venting Fig. # 8 Fig. # 34 Optional Blower BLOWER Connector SNAP DISC Caution: Use only a flue liner system approved by the ROCKER SWITCH Strap SWITCH local gas authority and install in accordance with the Electrical Supply: manufacturers instructions. Consult local and/or national 115 VOLTS building codes before altering fireplace.

  • Page 8: Blocked Vent Shut-Off System

    Blocked Vent Shut-off System Draft Inspection Propane Conversion Fig. # 31 Pilot This appliance is equipped with a blocked vent shutoff This appliance must be connected to a venting system with The appliance can be converted to Propane Gas as follows: system.

  • Page 9: Surround Assembly

    Burner Removal Surround Assembly Burner Pan Fig. # 13 Fig. # 14 Fig. # 28 Attachment Points Caution: Turn off gas and electrical power supply Warning: Failure to position the parts in accordance with and allow ample time for unit to cool before pro- these diagrams or failure to use only parts specifically ceeding.

  • Page 10: Log Set

    Log Set First Fire Primary Air Adjustment Fig. # 17a Log Tabs Unpack and inspect log set. There should be a When lit for the first time, the appliance will emit a slight odor This appliance is provided with a primary air adjustment, total of 7 logs.
  • Page 11 Lighting Instructions Fig. # 17d Step 5 Top Right Log Placement (log #5) FOR YOUR SAFETY READ BEFORE LIGHTING phone in your building. WARNING: If you do not follow these - Immediately call your gas supplier from a neigh- instructions exactly, a fire or explosion bour's phone.

  • Page 12: Glowing Embers

    Glowing Embers Louver Installation Fig. # 20 Fig. #23 Note: Use only glowing embers supplied with the Unpack and inspect all parts. A flathead or a #2 Robertson appliance. Use of any other materials or incorrectly screwdriver is required to install the louvers. placed embers may cause an incorrect flame pattern, sooting and/or delayed ignition.

This manual is also suitable for:

Fairfield

Table of Contents