Advertisement
19
Place canopy over fan body
aligning holes.
22
Hang fan from mounting bracket by
the hands free hook into a closed
hole on the edge of the Canopy.
25
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box. The splices, after
being made, should be turned upward and pushed
carefully up into the outlet box.
28
Install the blade holder assembly to
motor using the screws pre-installed.
Tighten screws securely.
20
Replace the 3 screws removed and
tighten securely. Check motor for
shipping stabilizers and remove if
present.
23
Hands free hook
For Canadian installation, the safety cable must be
installed into the house structure beams using the
3" lag screws provided. Make sure that when the
safety cable is fully extended the leadwires are
longer than the cable and no stress is placed on
the leadwires.
26
Lift fan to mounting bracket, aligning the "L"
shape holes with the scresws on the mount-
ing bracket. Turn the fan clockwise to lock
in position. Install the screws that were not
installed from earlier step. Tighten securely.
29
Remove the screws from switch
housing and save for use later.
21
Take 4 screws from hardware pack and
insert 2, one on each side of bracket to
match the L slot screw holes in canopy.
Keep 2 screws for later use. Remove the
all thread studs from the lower part of
the mounting bracket.
24
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to
White (Neutral) wire from house. Connect Ground
leads from mounting bracket and downrod to Ground
lead from house. refer to safety Tips section of
manual.
27
Install 3 screws ( screws are in the hardware
pack ) to back side of blade as shown. Tighten
the screws securely.
30
Install switch cap to fan using the 3
screws removed in step 29. Tighten
securely.
Advertisement
