Download Print this page
Monte Carlo Fan Company Rockland 4RKR60 D Series Owner's Manual And Installation Manual

Monte Carlo Fan Company Rockland 4RKR60 D Series Owner's Manual And Installation Manual

Advertisement

Quick Links

Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
4RKR60XXXD Series Fan
cETL Model NO. : 4RKR60
RETAILER NAME:
RETAILER ADDRESS:
6.6 kgs
14.52 lbs
Total fan weight with light

Advertisement

loading
Need help?

Need help?

Do you have a question about the Rockland 4RKR60 D Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Monte Carlo Fan Company Rockland 4RKR60 D Series

  • Page 1 Owner’s Guide and Installation Manual 4RKR60XXXD Series Fan cETL Model NO. : 4RKR60 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 6.6 kgs 14.52 lbs Total fan weight with light...
  • Page 2: Cautions And Warnings

    Note: Suitable for use in damp locations. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2019 Monte Carlo Fan Company 4/2019...
  • Page 3 Note: the end with bend should be brackets with set screws provided. screw for later use. upward, and the indent outward. Tighten screws securely. Note: Carefully handle it and do not damage the lead wires from motor. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 4 : Tuck the lead wires into the plate on socket assembly as shown in inset and make sure the light lead wires are not pinched between the light pan and the LED light fixture. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 5 Yoke cover Remove preassembled keeper pin and Place downrod over canopy, canopy Partially loosen downrod set screws from cross pin from downrod. bottom cap and yoke cover. yoke at top of motor assembly. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 6 Note : If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove to rotate without obstructions. Knockouts In The Outlet Box. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 7 Reinstall the screw removed in step 26 and tighten all screws securely. Attach canopy bottom cap onto canopy by aligning its notch with the screws on mounting bracket and twist clockwise till tight. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 8: Transmitter Operation

    Or you may turn power off for 15 seconds then turn power back, and then turn the fan on, Over load protection (current limit)- The device will limits the maximum current output from the receiver/drive when the fan or light load was increased abnormally. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 9 4. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 10: Troubleshooting

    5.Remove light kit and check the plug connections if they are present. 6.If this fan uses remote controller, make sure dip switches are setting properly and make CAUTION: Make sure main power is turned off before entering switch housing and/or canopy. © 2019 Monte Carlo Fan Company 4/2019...
  • Page 11 May.2019...