Advertisement
7
Tighten the 2 Set screws on the Yoke
once the downrod is in place.Check
motor for shipping stabilizers and
remove if present.
10
Make sure the studs protruding from
the bottom of the Mounting bracket
are installed with threads all the way
through the bracket.
13
Lift Canopy allowing the 2 studs
to protrude through the canopy.
16
Remove side covers from canopy
exposing 4 holes. 2 closed holes
and 2 open "L" shape holes.
8
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
11
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to
White (Neutral) wire from house. Connect Ground
leads from mounting bracket and downrod to Ground
lead from house. refer to safety Tips section of
manual.
14
Canopy disk
Next lift the canopy disk and install
knurled nuts as shown. Tighten the
knurled nuts securely. The canopy should
adjust for any irregularity in the ceiling or
Outlet box.
17
Remove every other screw as circled
and save for later use.
Safety cable installation
9
Safety Cable
Lag Screw
Lag Screw
Safety Cable
Washer
Lock Washer
For Canadian installation, the safety cable must be
installed into the house structure beams using the
3" lag screws provided. Make sure that when the
safety cable is fully extended the leadwires are
longer than the cable and no stress is placed on
the leadwires.
12
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box. The splices, after
being made, should be turned upward and pushed
carefully up into the outlet box.
15
Flush Mount Installation
Pass leadwires and safety cable
through the canopy.
18
Install rubber pad between fan
body and canopy.
Advertisement
