Using The Wireless Alarm System - Mace MAS-WA-SYS User Manual

2.3 u
nderStandinG
Battery icon shows
power status:
FULL
HIGH
MIDDLE
LOW
AC Adaptor icon
SECTION 3: USING THE WIRELESS ALARM SYSTEM
3.1 P
rOGramminG
The Wireless Alarm Panel is supplied with a default PIN of "1234". This can be changed to your own
personalized PIN, or your own personalized PIN can be changed, as follows:
Keys
(1234 or 4-digit
1
PIN) +
(1234 or 4-digit
2
PIN) +
3
New 4-digit PIN
4
+
New 4-digit PIN
5
+
8
B
the attery
Battery icon shows when the AC power supply is unplugged or interrupted.
9V battery functions as BACK-UP only and the
BATTERY.
The LCD backlight flashes YELLOW for 30 seconds and
the new battery is replaced or the mains power supply (with AC adaptor) is
plugged in.
When the AC adaptor to the Wireless Alarm Panel is connected to a wall
socket, the AC symbol
The backlight will be 'ON' for 10 seconds while the AC adapter connects to
the power supply.
n
yOur ew
Description
You must be in STANDBY
mode before programming
your new 4-digit PIN
Enter the default PIN " 1–2–3-4"
OR your new 4-digit PIN
followed by
Press followed by
Enter the new 4-digit PIN
followed by
Re-enter new PIN for
followed by for final
confirmation
& ac a
daPtOr
will appear.
4-d Pin
iGit
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 "
- Press
- The panel will display the image below when you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three
beeps indicate that an invalid operation was performed).
The panel will display the below image:
- Press then "1" to set the new PIN
- The panel will display the below image :
- LCD display flashes with "1"
- Enter the new 4-digit PIN
- Press to confirm
- LCD display flashes with "2"
- Re-enter the new 4-digit PIN
- Press for final confirmation
(One beep indicates that you entered a valid PIN, two
beeps indicate that an invalid operation was performed).
i
cOn
symbol means LOW
will blink until