Table of Contents
Advertisement
e. a
S
rminG
the
yStem
On the Keychain Remote Control: Press
On the Wireless Alarm Panel: First make sure the panel is in STANDBY mode, and then ARM the
system by taking the following steps:
Keys
(1234 or 4-digit
1
PIN) +
(1234 or 4-digit
2
PIN) +
+
When in ARM mode, the Wireless Alarm Panel flashes RED every 5 seconds, acting as a deterrent to
potential intruders. However, if an intruder is detected the panel continuously and rapidly flashes RED.
Once an intrusion has occurred (with the zone triggered under ARM status), the alarm siren will
sound and the panel flashes RED every 1.5 seconds with the triggered zone indicated. After the initial
triggering, the alarm will immediately sound, without delay, if any other sensors are triggered.
f. d
iSarminG
the
• On the Wireless Alarm Panel: Enter your 4-digit PIN followed by
• On the Keychain Remote Control: Press
G. Z
One
SettinGS
Programming each zone in ARM mode:
Keys
(1234 or 4-digit
1
PIN) +
12
Description
You must be in STANDBY
mode before turning to
ARM mode
Enter 4-digit PIN, press
and
for ARM mode
SyStem
Description
You must be in STANDBY
mode before turning to
ARM mode
to ARM the system.
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
.
- The panel will display the below image while you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).
Exit delay: Up to 15 seconds
– There is a 15 second exit delay time with a visual and audible
(beeping) countdown before the system is armed.
(Press MUTE to disable the beeping countdown, press
MUTE again to resume the beeping)
– If the Zone is enabled, a number will appear as displayed in
the image below:
- The system will then enter ARM mode after 15 seconds.
to disarm the system
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
.
- The panel will display the below image while you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).
to disarm the system.
Advertisement
Table of Contents
Troubleshooting
