Table of Contents
Advertisement
3.2 t
ranSmittinG
3.2.1 u
P
SinG
the
anic
Pressing
&
buttons together on the Keypad or Keychain Remote Control will immediately
transmit an alarm signal to the Wireless Alarm Panel, activating the siren, and transmitting an alarm
signal to any optional response devices.
To disarm the Panic alarm
On the Wireless Alarm Panel: Enter your 4-digit PIN followed by
On the Keychain Remote Control: Press
3.2.2 u
P
SinG
the
anic
If you are forced to disarm the system, enter the Duress Password to stop the siren from sounding.
The Wireless Alarm Panel will then silently transmit an alarm signal to the optional response devices.
Duress Password:
Enter the default 4-digit PIN + "1" (
OR
Enter your personalized 4-digit PIN +
3.3 O
PeratinG
The system has 4 operating modes (STANDBY, ARM, ALERT, and HOME) to suit individual
requirements. These modes can be set as follows:
3.3.1 S
m
tandBy
Ode
If in STANDBY mode, the Wireless Alarm Panel is prepared for mode selection.
Keys
(1234 or 4-digit
1
PIN) +
3.3.2 arm m
Ode
When in ARM mode, the Wireless Alarm Panel siren will sound and the panel display flashes RED every
1.5 seconds when the system is triggered.
ARM mode default setting:
Sensor
• Door/Window Sensor
• Door/Window Sensor
• Motion Sensor
e
an
merGency
alarm
to exit from the Panic alarm.
a
larm
withOut
+
d
m
ifferent
Description
You must be in STANDBY
mode before turning to
ARM mode
Zone
1
2
8
(P
) a
anic
a
S
ctivatinG
the
+
) +
OdeS
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
.
- The panel will display the below image while you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three
beeps indicate that an invalid operation was performed).
Status (MODE)
ARM
ARM
ARM
larm
to exit from the Panic alarm.
iren
9
Advertisement
Table of Contents
Troubleshooting
