Mace MAS-WA-SYS User Manual page 19

Keys
(1234 or 4-digit
1
PIN) +
(1234 or 4-digit
2
PIN) +
3
4
. O
iii PeratinG the
The remote can be used to arm, disarm, and operate the system instantly.
ARM:
Pressing the ARM button on the remote will arm the system, triggering the preset exit delay.
When triggered the Wireless Alarm Panel's LCD display will flash Red and indicate the triggered zone.
DISARM:
Pressing the DISARM button on the remote will
disarm the system instantly and the system will
return to STANDBY mode.
ALERT:
Pressing the ALERT button on the remote will put
the system into ALERT mode and a chime will
sound if any of the sensors are triggered. The LCD
display will flash Green and indicate the triggered
zone.
HOME:
Pressing the HOME button on the remote will set
the system in HOME mode which will operate the
system in both ARM and ALERT modes in different
preset zones.
PANIC:
If the HOME and ALERT buttons are pressed together the systems alarm is immediately activated.
Description
You must be in STANDBY
mode before enrolling a new
Remote Control onto the
Wireless Alarm Panel
Enter the default PIN
" 1–2–3–4 " OR your new
4-digit PIN for setting
followed by
Press then to enter
the Remote Control Enroll
mode. Then press any key on
the new Remote Control to
enroll it onto the system.
Press to complete the
setting
k r
eychain emOte
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).
The panel will display the below image:
LCD display flashes the ID no. of the remote to be enrolled
e.g. when enrolling the first remote ID no. "01" will flash. Once
the first remote is enrolled the "02" will flash ready for a second
remote to be enrolled (One beep indicates that the remote was
enrolled to the panel successfully)
Note: It is recommended that the ID No. is marked on the
remote in case it needs to be deleted at a later stage
Confirm the setting and return the panel to STANDBY
by pressing
c
OntrOl
19