Deleting A Remote Control From The Wireless Alarm Panel; Querying The Id Number Of A Remote Control - Mace MAS-WA-SYS User Manual

. d r
iv eletinG a emOte
If a Remote Control device is damaged or lost, it can be deleted from the system as follows:
Keys Description
You must be in STANDBY
(1234 or
mode before deleting a
1
4-digit PIN) +
Remote Control from the
Wireless Alarm Panel
Enter the default PIN
(1234 or
" 1–2–3–4 " OR your new
2
4-digit PIN) +
4-digit PIN for setting
followed by
Press
enter the Remote Control
Deleting mode. Then input
3
the ID no. of the Remote
Control you wish to delete
from the system
Press
4
the setting
. Q id n
v ueryinG the
The ID number of a Remote Control device can be identified as follows:
Keys Description
You must be in
STANDBY mode before
(1234 or
querying the ID number
1
4-digit PIN) +
of a Remote Control
from the Wireless Alarm
Panel
Enter the default PIN
(1234 or
" 1–2–3–4 " OR your new
2
4-digit PIN) +
4-digit PIN for setting
followed by
20
c
OntrOl frOm the
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in STANDBY
mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).
The panel will display the below image:
• LCD display flashes the total number of remote currently
then to
• Input the remote ID no. (e.g. "02") for the remote you wish to
• LCD display will then flash the total number of remotes
Confirm the setting and return the panel to STANDBY
to complete
by pressing
r
umBer Of a emOte
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in STANDBY
mode:
(One beep indicates that you entered a valid PIN, three beeps indicate
that an invalid operation was performed).
The panel will display the below image:
w a
ireleSS larm
enrolled to the system (e.g. If the panel has 3 remotes enrolled
the LCD display will flash "03")
delete (Inputting "00" will delete all remote controls)
enrolled after deletion(One beep indicates that the remote was
successfully deleted from the panel)
c
OntrOl
P
anel