Adjusting Exit Delay; Adjusting Entry Delay - Mace MAS-WA-SYS User Manual

a. a e
djuStinG xit
The default setting of the Wireless Alarm Panel allows the user 20 seconds to exit the property before
the alarm is ARMED. However, this Exit Delay can be adjusted to between 10 — 60 seconds as follows:
Keys
(1234 or 4-digit
1
PIN) +
(1234 or 4-digit
2
PIN) +
3
4
B. a e
djuStinG ntry
The default setting of the Wireless Alarm Panel allows the user 30 seconds to enter the property and
DISARM the alarm before it is triggered. However, this Entry Delay can be adjusted to between 10—60
seconds as follows:
Keys
(1234 or 4-digit
1
PIN) +
(1234 or 4-digit
2
PIN) +
10
d
elay
Description
You must be in STANDBY
mode before adjusting the
Exit Delay
Enter the default PIN " 1–2–3–
4" OR your new 4-digit PIN
for setting followed by
Press then
(as many times as required)
to set the new Exit Delay
Press to complete the
setting
d
elay
Description
You must be in STANDBY
mode before adjusting the
Entry Delay
Enter the default PIN " 1–2–3–
4" OR your new 4-digit PIN for
setting followed by
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the image below when you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three
beeps indicate that an invalid operation was performed).
The panel will display the below image:
• When is pressed the first time the panel flashes with
the number of seconds currently set for the Exit Delay
(The factory default setting is 20 seconds)
• Each time is pressed the Exit Delay is increased by a
further 10 seconds between the adjustable range of 10 to
60 seconds
• The Exit Delay time on the LCD display will flash until the
setting is completed
Confirm the setting and return the panel to STANDBY by
pressing
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the image below when you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three
beeps indicate that an invalid operation was performed).
The panel will display the below image: