Adjusting The Alarm Duration; Muting The Audible Countdown - Mace MAS-WA-SYS User Manual

3
4
c. a
djuStinG the
The default setting of the Wireless Alarm Panel gives an alarm duration of 1 minute after being
triggered. However, this alarm duration can be increased up to 6 minutes:
Keys
(1234 or 4-digit
1
PIN) +
(1234 or 4-digit
2
PIN) +
3
4
d. m a
utinG the udiBle
When the Wireless Alarm Panel is ARMED the audible countdown (beeper) can be silenced by
pressing the MUTE button, during the countdown. To reactivate the audible countdown (beeper)
simply press the MUTE button again.
Press then
(as many times as required)
to set the new Entry Delay
Press to complete the
setting
a d
larm uratiOn
Description
You must be in STANDBY
mode before adjusting the
Alarm Duration
Enter the default PIN " 1–2–3–4"
OR your new 4-digit PIN for
setting followed by
Press then
(as many times as required)
to set the new Alarm Duration
Press to complete the
setting
c
OuntdOwn
• When is pressed the first time the panel flashes with
the number of seconds currently set for the Entry Delay
(The factory default setting is 30 seconds)
• Each time is pressed the Entry Delay is increased
by a further 10 seconds between the adjustable range of
10 — 60 seconds
• The Entry Delay time on the LCD display will flash until the
setting is completed
Confirm the setting and return the panel to STANDBY
by pressing
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the image below when you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three
beeps indicate that an invalid operation was performed).
The panel will display the below image:
• When is pressed the first time the panel flashes
with the number of minutes currently set for the Alarm
Duration (The factory default setting is 1 minute)
• Each time is pressed the alarm duration is
increased by a further minute up to a maximum of
6 minutes
• The Alarm Duration on the LCD display will flash until the
setting is completed
Confirm the setting and return the panel to STANDBY
by pressing
11