Home Mode; Entering The Home Mode; Exiting The Home Mode; Zone Settings - Mace MAS-WA-SYS User Manual

3.3.4 hOme m
Ode
There are default settings that allow the system to operate after opening the package. These settings
can be adjusted to suit your individual requirements The HOME mode allows the system operate in
both the ARM and ALERT modes in different zones.
HOME mode default setting:
Sensor
• Door/Window Sensor
• Door/Window Sensor
• Motion Sensor
a. e hOme m
nterinG the
• On the Keychain Remote Control: Press
• On the Wireless Alarm Panel: First make sure the panel is in STANDBY mode, and then enter HOME
mode by taking the following steps:
Keys
(1234 or 4-digit
1
PIN) +
4-digit PIN +
2
+
B. e hOme m
xitinG the
• On the Wireless Alarm Panel: Enter your 4-digit PIN followed by
• On the Keychain Remote Control: Press
c. Z S
One ettinGS
Programming each zone in HOME mode:
Keys
(1234 or 4-digit
1
PIN) +
Zone
1
2
8
Ode
Description
You must be in STANDBY
mode before turning to

HOME mode

Enter 4-digit PIN, press
for HOME mode
and
Ode
Description
You must be in STANDBY
mode before turning to
HOME mode
Status (MODE)
ALERT
ALERT
ARM
to activate.
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).
- Then system will enter HOME mode
- If the Zone is enabled, a number will appear as displayed in the
image below:
to exit HOME mode.
Note
*To make sure you are in STANDBY mode:
- Enter the default PIN " 1–2–3–4 " OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).
to exit HOME mode.
15