Table of Contents
Advertisement
(1234 or 4-digit
2
PIN) +
3
4
h. t
arm m
riGGerS
in
Example: Zone 1 trigger
Step
Description
1
Under the "ARM" Mode
2
System trigger
3
Entry delay 30 seconds
Return to ARM mode after
4
the initial triggering
3.3.3 alert m
Ode
If in ALERT mode, the Wireless Alarm Panel chime will sound and the Wireless Alarm Panel flashes
GREEN every 1.5 seconds with the triggered zone indicated, when the system detects a visitor in the
protected area. ALERT mode default settings:
Sensor
• Door/Window Sensor
• Door/Window Sensor
• Motion Sensor
Enter 4-digit PIN for setting
followed by
Press
then
to set
the ARM mode
Press
to complete the
setting
Ode
Note
The panel will display the below image:
One beep indicates that the system is triggered.
There are 30 seconds of entry delay time with a visual countdown for disarming.
Once an intrusion has occurred (zone triggered under ARM status), the alarm siren
will sound for 1 minute and the panel display flashes RED every 1.5 seconds with the
triggered zone indicated, until the system is disarmed.
*To disarm the system, enter the 4-Digit PIN or press
After the initial triggering, the alarm will immediately sound, without delay, if any
other sensors are triggered.
Zone
1
2
8
The panel will display the below image:
– Toggle 1, 2, 3, 4, 5, 6, 7, 8 to turn each zone ON or OFF
– If no number appears, the zone is turned OFF
– The panel will display the below image:
Confirm the setting and return the panel to STANDBY
by pressing
Status (MODE)
ALERT
ALERT
ALERT
on the remote control.
13
Advertisement
Table of Contents
Troubleshooting
